Hengshui Huaguan Machinery

The feed pellet machine is a feed pellet machine with high output and strong continuous working ability! It is simple to operate and easy to use. It is specially designed for cattle, sheep, chicken, duck, goose and other farmers. It mainly solves the problem of low utilization rate of large amounts of wheat, soybean, corn and other straw in rural areas. It can be said that straw is crushed and processed into straw feed pellets. Users can also mix various materials in any proportion according to their own needs and process them into pellets. Unlike other pellet machines, the proportion of grass powder and straw powder must be limited to save money on breeding. cost. Straw can also be processed into fuel pellets, which are used to debug the burning feed pellet machine. Model Brand Huaguan
Weight Power Supply Voltage
Feed Type Pellet Feed Productivity
Overall Dimensions**
Use a tapered press wheel, and both ends are in line with the inner and outer circles of the mold plate The speed is consistent, there is no misalignment friction between the wheel and the mold, which reduces resistance, reduces kinetic energy loss, extends the service life of the mold, and reduces production costs.
The pelletizing room is equipped with three doors, and materials can be cleaned at any time to facilitate equipment maintenance and debugging of the feed pellet machine.
The pressure rollers are evenly distributed to ensure smooth operation. At the same time, the pressing area is increased to improve production efficiency.
, Adopt screw stalk center pressure regulating structure, the mold gap can be increased or decreased to adapt to different materials and ensure the pressing effect.
Precautions
When a new machine is used for the first time, it must be run-in or it will not work properly.
, type lighting power supply, the power cord should be no less than square meters of copper wire, and the instrument should be -.
When the pellet machine is working, do not put your hands into the feeding port. If necessary, you can use a wooden stick to help feed.
Before starting the machine, you must add a little less material and then turn it on. When shutting down, a small amount of feed should be left in the machine to prevent the machine's pressure roller from contacting the template and idling.
If the machine gets stuck during operation, stop the machine immediately, tighten the pressure roller until the bolts are loose and flat, and then restart the machine.
. After each work is completed, the adjustment roller bolt must be loosened to debug the feed pellet machine.
After the machine has been used for a certain period of time or a certain number of pellets are pressed out, if the pellets produced are broken into pieces or the particles are not solid, the grinding plate should be turned over to the bottom and mixed with water and added to the feed.
Frequently check the tightness of the belt to prevent low machine output and belt slippage.
When the pellet machine is used for the first time, it needs to work at low load for about an hour, and then replace the gear oil in the gearbox. In the future, they should be replaced regularly every hour, and all bearings should be lubricated regularly.